CertifiedCopyright 2012 BPL Techno Vision Ltd. All rights reserved.BPLBPL IQ Gateway33/09/2012 11:00 AM8/23/2012 04:00 PMBPLBPL IQ Gatewaydevices_sm/LutronNetwork.gifdevices_lg/LutronNetwork.giflua_genDriverWorksserialothersOthersbpl_iq_gatewaytruebpl_iq_gateway_protocol_driver
BPL IQ Gateway driver
While adding BPL devices to the Control 4 System, this is the first driver that needs to be installed.
Individual device drivers are subsequently to be added and a connections need to be made to this gateway
driver.
After powering on the BPL gateway device, the heart beat led would start blinking to indicate this device
is up and ready to use.
By default the IP Address of the gateway is set to 192.168.0.1, this can be changed in the Properties page.
To configure the BPL gateway driver for TCP/IP connection to the Control4 system, IP address of the
gateway needs to be entered in Network tab under Connections. Connection led comes on the gateway indicating
a successful connection. This led reflects the connection status at all times between the gateway and
the Control4 system.
Factory Reset button is provided in the action tab. To factory reset the gateway device, hold down
the Factory button on bottom of gateway device and press the Factory Reset button. The heart beat led would
stop and will start blinking again after the factory reset is completed.
Adding/configuring specific devices:
The following BPL devices can be added to Control4 system.
* Dimmer
* Motion sensor
* Door/Window sensor
* LPG sensor
* LPG Valve controller
* Geyser control
* 3-button keypad
Prerequisite for adding BPL devices:
Check for the led on gateway device, to confirm the connection with Control4 system is established.
If desired, further integrate the BPL Gateway / Devices with the Control4 system using one or more of the
following capabilities:
* Lighting Scenes [Macros, Agents, Lighting Scenes]
* Programming (events, conditionals, actions) [Programming]
BPL device drivers are available under System Design, Search, Manufacturer [BPL]. Check the individual
driver documentation for details on adding/configuring them.
For Technical Support, please contact:
Email : Support.BPLIQ@bpl.in
Phone : +91 80 32719381
Please enter the IP address of the BPL IQ Gateway.Enable Permit Join(60 Sec)PERMIT_JOINFactory ResetFACTORY_RESETNetwork StatusSTRINGOfflinetrueIP ConfigSTRING192.168.0.1falseDebug ModeLIST- Off
- Print
- Log
- Print and Log
OfffalseControl4 certified on 9/13/2012 for software released versions: 2.2.2text for the unknown90%90%60016Network Connection4TrueFalseFalseTrueTCP30002FalseFalseFalse16BPL Proxy1FalseFalseFalseTrueBPL_PROXYTrue