CertifiedCopyright 2012 BPL Techno Vision Ltd. All rights reserved.BPL1BPL3/09/2012 11:00 AM6/14/2012 04:00 PMBPL IQ Motion SensorBPL IQ Motion Sensorbpl_iq_motionsensortrueDriverWorkslua_genothersSensorsdevices_sm/contactsingle_motionsensor_close.gifdevices_lg/contactsingle_motionsensor_close.gif1Battery LowOn NAME Battery Low2TamperOn NAME Tamper1devices_sm\contactsingle_motionsensor_open.gifdevices_lg\contactsingle_motionsensor_open.gif2devices_sm\contactsingle_motionsensor_close.gifdevices_lg\contactsingle_motionsensor_close.gif
BPL IQ Motion Detector driver
Prerequisite:
1. Check for the led on gateway device, to confirm the connection with Control4 system is up.
2. Add a Generic Motion Sensor device driver as proxy
Adding BPL Motion Sensor device
Go to System Design, search Device type:--others-- and Manufacturer:BPL.
Configuration
On the properties page of the BPL Motion sensor driver,
1. IEEE : Enter the IEEE number of the device.
Adding the BPL Motion sensor device to Network
1. On the Actions page of gateway driver, click on Permit Join button. [This opens a 60 seconds window
on the gateway, for devices to join]
2. Press and hold the factory button on the device and insert the batteries. Factory reset on the device
is indicated by the green led flashing rapidly. Now power cycle the device(remove and put back the batteries)
On successfull join, the green led on the device will flash 5 times.And the properties page of the
BPL Motion sensor will indicate the Network status as "Online"
For Technical Support, please contact:
Email : Support.BPLIQ@bpl.in
Phone : +91 80 32719381
Set IEEESTRING00137A000000565BfalseDB StatusSTRINGDevice not presenttrueNetwork StatusSTRINGOfflinetrueBattery StatusSTRINGOktrueDebug ModeLIST- Off
- Print
- Log
- Print and Log
Offfalse16BPL IQ Proxy1TrueFalseFalseTrueBPL_PROXYTrue26Contact Sensor1FalseFalseFalseFalseCONTACT_SENSORTrueCertifiedrelay