Copyright 2008 Control4 Corporation. All rights reserved.Card AccessCard Access7/20/2009 12:30 PM9/18/2009 12:30 PMCard Access Expansion Bridge V2ZGB20-XP1devices_sm/c4modI_16.gifdevices_lg/c4modI_32.giflua_genControllersotherstruecardaccess_bridge_expansion_ZGB20DriverWorksc4:cardaccess_inhome:ZGB20AlwaysOn60016ZIGBEE4TrueFalseFalseFalseZIGBEE1006Expansion Bridge1TrueFalseFalseFalseBRIDGE_EXTTrueDriver ZGB20-XP version 1.0\n\nThis Card Access DriverWorks driver is only for additional "expansion" Card Access Sensor Bridge V2's used in the same project.\n\nThis DriverWorks driver is used ONLY in conjunction with an already installed ZGB20 driver. If only one Sensor Bridge is used in the project, then the Expansion Bridge Driver V2 is not needed.\n\nGE advises the maximum transmission range for their Wireless Sensors is 100 feet. When this is insufficient, Expansion Bridges are used to increase the coverage area for these GE Wireless Sensors.\n\nWhen using two or more Sensor Bridges in the project, you must first add one ZGB20 driver for the first Sensor Bridge. Then, you will add one instance of this Expansion Bridge V2 driver (ZGB20-XP) for each additional bridge.\n\nA total of four (4) bridges may be used in a single project.\n\nTo view diagnostic information on Expansion Bridges, refer to the properties page of the primary Sensor Bridge ZGB20 driver.\n\nNOTE: GE Wireless Sensors do NOT need to be associated in any way with a specific Sensor Bridge, nor are there any bindings that need to be made between bridges.\n\nRemove the plastic cover on the unit and press the IDENTIFY button four (4) times.Bridge NameSTRINGunnamedfalseZigBee StatusSTRINGnot addressedtrueDebug ModeLISTOffPrintLogPrint and LogOfffalsezigbee