Copyright 2008-2010 Mode Lighting Ltd. All rights reserved.Control4Mode Lighting Ltd.07/01/200805/12/20102 Channel Relay Module2 Channel Relay Module14devices_sm/relay2.gifdevices_lg/relay2.giflua_genMotorizationotherstruerelay_mbus_modelighting_evorp0302DriverWorksTrueAlwaysOn16Mode Lighting MBus1TrueFalseFalseFalseMODE_MBUSTrue1016RELAY 11FalseFalseFalseTRUERELAY1026RELAY 21FalseFalseFalseTRUERELAYThis is the 2 Channel Relay Module driver. This driver requires the MBUS Interface driver to communicate with the Relay Module Unit. The MBUS Interface driver should always be added FIRST to a project BEFORE adding any other Mode Lighting drivers. This is because the other 'client' drivers are designed to 'Auto-Bind' to the EVO-INT-232 driver when they are added. If the EVO-INT-232 driver is not present when other drivers are added, they cannot auto-bind, and therefore they would need to EACH be manually bound at a later time. Once the Relay Module driver is bound to the MBUS Interface driver, set the Relay Module address in the properties to establish a link with the physical unit. Each module, regardless of its model number, must have a distinct address on the Mode Lighting MBUS. If you need to change the address of a module, you must unbind the connection to the MBUS Interface driver first, change the address then bind again to the MBUS Interface driver. Module AddressRANGED_INTEGER02550falseRelay 1 StateSTRINGtrueRelay 2 StateSTRINGtrueDebug ModeLISTOffPrintLogPrint and LogOfffalserelay