Copyright 2008-2010 Mode Lighting Ltd. All rights reserved.Mode LightingMode Lighting Ltd.07/01/200805/12/2010Evo Lighting SceneEvo Lighting Scene14devices_sm/dimmer.gifdevices_lg/dimmer.giflua_genLightslightlightDriverWorksTrueTrueTrueFalseFalseFalseFalseFalseFalseFalseFalseFalseFalseFalseFalseFalseFalseFalseFalseFalseTrueAlwaysOn50016Light2FalseFalseFalseFalseLIGHT16Mode Lighting MBus1TrueFalseFalseFalseMODE_MBUSTrue3006Top Button Link1FalseFalseFalseTrueBUTTON_LINK3016Bottom Button Link1FalseFalseFalseTrueBUTTON_LINK3026Toggle Button Link1FalseFalseFalseTrueBUTTON_LINKThis is the Evo Lighting Scene driver. This driver requires the MBUS Interface driver to communicate with the Physical Pack containing the scene settings. The MBUS Interface driver should always be added FIRST to a project BEFORE adding any other Mode Lighting MBUS enabled drivers. This is because the other 'client' drivers are designed to 'Auto-Bind' to the MBUS Interface driver when they are added. If the MBUS Interface is not present when other drivers are added, they cannot auto-bind, and therefore they would need to EACH be manually bound at a later time. Once the Evo Lighting Scene driver is bound to the MBUS Interface driver, set the Physcal Pack address and Logical Scene Number in the properties to establish a link with the scene setting. Each physical pack, regardless of its model number, must have a distinct address on the Mode Lighting MBUS, but can drive any number of logical scenes. If you need to change the address of the pack driving the scene, you must unbind the connection to the MBUS Interface first, change the address then bind again to the MBUS Interface driver.Scene NumberRANGED_INTEGER1655351falseON Preset Level (0-100)RANGED_INTEGER0100100falseClick Ramp Rate Up (S)RANGED_INTEGER0321falseClick Ramp Rate Down (S)RANGED_INTEGER0322falseHold Ramp Rate Up (S)RANGED_INTEGER0325falseHold Ramp Rate Down (S)RANGED_INTEGER0325falseButton Link ON Color (rgb hex)STRING000058falseButton Link OFF Color (rgb hex)STRING000000falseDebug ModeLISTOffPrintLogPrint and LogOfffalseother